![]() ![]() Older versions of the NAM component of the Cisco An圜onnect Secure Mobility Client will not work when you try to connect to a wireless network on a Surface Pro 3. Note This issue is unrelated to the VPN features of the Cisco An圜onnect software. The Wireless > Configure > Access Control page is used to configure per-SSID Access Control settings such as association security settings, splash page settings, and client addressing options.This article is designed to mirror the Access Control page and goes into detail about every option available from top to bottom. This issue is specific to the wireless NAM component of the Cisco An圜onnect Secure Mobility Client. Just as an authenticated wireless client must submit a set of credentials to be validated before being allowed to send wireless frames to the intranet, an IEEE 802.1X wired client must also perform authentication prior to being able to send traffic over its switch port. This issue is resolved in Cisco An圜onnect Secure Mobility Client version 2. ![]() I don't want to blame gargoyle, perhaps it's a PEBCAK or another problem.Please see Cisco's release notes for more information. It worked!Ĭan someone help me to solve this problem? This comes out, when I try to ping from a client in the wlan to the client behind the wlan client bridge:Ĭode: Select all tcpdump -vv -nn -i any host 172.20.51.2 and host 172.20.50.3 On this device is my desktop connected (cable, IP 172.20.50.3)įrom the desktop I can connect to the internet I can access the client bridge and the router, But I can't access any other clients, connected to the router (no ping, no ssh, nothing)įrom the router I can ping the client bridge, and the clients connected to the client bridge.įrom the clients connected with wlan to the router I can't access (ping, ssh, whatever) the client bridge and the clients connected to the client bridge device. I have additionally a WRT54GS with latest Gargoyle configured as wlan client bridge (IP 172.20.10.2). Some clients (Laptops and my PS3) are connected to this device using wlan with wpa2. I have a WNDR3700 running with openwrt 10.03.1-rc4 as router and WLAN AP with IP 172.10.1.1. The strangeness completes itself because in the beginning it worked perfectly, but it stopped without changing something from my side (ok i can't remember that I changed something) I don't know wether the problem is really located inside gargoyle, but I have to start somewhere to ask for help Set up as an client bridge was so easy I couldn't believe it. ![]() First, thank you for this great router firmware! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |